Waters Network Systems ProSwitch-Xtreme Guide d'installation

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 1 INSTALLATION GUIDE AND OPERATING MANUAL ProSwitch-Xtreme

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 8 available through their own submenu. The port map for the Link-Loss Learn faci

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 9 There are system parameters that affect the whole switch. The following system

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 10 4.4 VLAN Configuration 4.4.1 Port-Based Virtual LANs (Static VLANs) A VLA

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 11 4.5.1 QoS Configuration from CMI The CMI provides two controls for QoS. The

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 12 4.8 Ageing Time Users can select the Address table Ageing Time between 10–1

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 13 ) Note: If you are accessing the CMI through the network, and if the IP Addre

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 14 5.2.1 Manager This level allows access to all console interface areas. Pleas

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 15 6.0 Troubleshooting All Waters’ switching products are designed to provide r

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 16 occurrence of the problem. Any changes to system administration procedures s

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 17 6.4 Warranty Waters Network Systems makes no express or implied warranties i

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 2 TABLE OF CONTENTS 1.0 GETTING STARTED WITH SWITCH CONFIGURATION ...

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 1 1.0 Getting Started with Switch Configuration This section provides a quick o

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 2 When a CMI session begins, the login screen is displayed. You have to ente

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 3 and reset the switch. The switch will go through the reset sequence and you wi

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 4 Disable DHCP if you only want the manually configured IP Address to be used.

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 5 2.3 SNMP You can manage the switch via SNMP from a network management station.

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 6 Supported Standard MIBs include:  SNMP MIB-II (RFC 1213)  Bridge MIB (RFC

12 ProSwitch- Xtreme User’s Manual (Managed Models) Page 7 Use the Telnet client to connect to the switch. You will need the IP address